Hoila,
ich habe folgendes:
pci error interrupt at aeqaddr = 0x9
data parity error detected during address or write data phase
Dieser Fehler taucht immer dann auf, wenn ich die 2. Netzwerkkarte eingebunden habe.
Im Netz gibt es keine Antworten auf das Problem, der Witz ist, dass dies schon bei 2 anderen Rechner ebenfalls passierte, die auch 2 Netzwerkkarten hatten. Also liegt es weniger an der Hardware.
Selbst verschiedene Distributionen habe ich probiert. RedHat 7.2, Suse 8.1 und Debian 3.1. Überall kommt der selbe Fehler.
cat /proc/interrupts
CPU0
0: 394533 XT-PIC timer
1: 1189 XT-PIC keyboard
2: 0 XT-PIC cascade
8: 4 XT-PIC rtc
9: 72817 XT-PIC aic7xxx, usb-uhci
10: 185 XT-PIC eth1
11: 13251 XT-PIC eth0
NMI: 0
LOC: 394481
ERR: 0
MIS: 0
--------------------------------------------------------
cat /proc/interrupts
CPU0
0: 394533 XT-PIC timer
1: 1189 XT-PIC keyboard
2: 0 XT-PIC cascade
8: 4 XT-PIC rtc
9: 72817 XT-PIC aic7xxx, usb-uhci
10: 185 XT-PIC eth1
11: 13251 XT-PIC eth0
NMI: 0
LOC: 394481
ERR: 0
MIS: 0
fileserver:~#
fileserver:~# cat /proc/ioports
0000-001f : dma1
0020-003f : pic1
0040-005f : timer
0060-006f : keyboard
0070-007f : rtc
0080-008f : dma page reg
00a0-00bf : pic2
00c0-00df : dma2
00f0-00ff : fpu
02f8-02ff : serial(set)
03c0-03df : vga+
03f8-03ff : serial(set)
0cf8-0cff : PCI conf1
b400-b4ff : Realtek Semiconductor Co., Ltd. RTL-8139
b400-b4ff : 8139too
b800-b8ff : Davicom Semiconductor, Inc. Ethernet 100/10 MBit
b800-b8ff : dmfe
d000-d0ff : Adaptec AHA-2940U2/W / 7890
d000-d0ff : aic7xxx
d400-d41f : Intel Corp. 82371AB PIIX4 USB
d400-d41f : usb-uhci
d800-d80f : Intel Corp. 82371AB PIIX4 IDE
d800-d807 : ide0
d808-d80f : ide1
e400-e43f : Intel Corp. 82371AB PIIX4 ACPI
e800-e81f : Intel Corp. 82371AB PIIX4 ACPI
--------------------------------------------------------
Falls noch was an Infos fehlt kurz fragen. Dank im voraus für die Hilfe. Ich habe aufgegeben das Problem selbst zu lösen nachdem ich so oft neuinstalliert habe. Wie schon erwähnt habe ich die Vermutung eines Treiberkonflikts des AIC7xxx, aber was es genau ist keine Ahnung.
Ciao
Firebolt
Linux 14.983 Themen, 106.387 Beiträge
Nachtrag:
cat /proc/pci
PCI devices found:
Bus 0, device 0, function 0:
Host bridge: Intel Corp. 440BX/ZX - 82443BX/ZX Host bridge (rev 2).
Master Capable. Latency=64.
Prefetchable 32 bit memory at 0xe4000000 [0xe7ffffff].
Bus 0, device 1, function 0:
PCI bridge: Intel Corp. 440BX/ZX - 82443BX/ZX AGP bridge (rev 2).
Master Capable. Latency=64. Min Gnt=136.
Bus 0, device 4, function 0:
ISA bridge: Intel Corp. 82371AB PIIX4 ISA (rev 2).
Bus 0, device 4, function 1:
IDE interface: Intel Corp. 82371AB PIIX4 IDE (rev 1).
Master Capable. Latency=32.
I/O at 0xd800 [0xd80f].
Bus 0, device 4, function 2:
USB Controller: Intel Corp. 82371AB PIIX4 USB (rev 1).
IRQ 9.
Master Capable. Latency=32.
I/O at 0xd400 [0xd41f].
Bus 0, device 4, function 3:
Bridge: Intel Corp. 82371AB PIIX4 ACPI (rev 2).
IRQ 9.
Bus 0, device 6, function 0:
SCSI storage controller: Adaptec AHA-2940U2/W / 7890 (rev 0).
IRQ 9.
Master Capable. Latency=32. Min Gnt=39.Max Lat=25.
I/O at 0xd000 [0xd0ff].
Non-prefetchable 64 bit memory at 0xd5800000 [0xd5800fff].
Bus 0, device 11, function 0:
Ethernet controller: Davicom Semiconductor, Inc. Ethernet 100/10 MBit (rev 49).
IRQ 10.
Master Capable. Latency=32. Min Gnt=20.Max Lat=40.
I/O at 0xb800 [0xb8ff].
Non-prefetchable 32 bit memory at 0xd5000000 [0xd50000ff].
Bus 0, device 12, function 0:
Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139 (rev 16).
IRQ 11.
Master Capable. Latency=32. Min Gnt=32.Max Lat=64.
I/O at 0xb400 [0xb4ff].
Non-prefetchable 32 bit memory at 0xd4800000 [0xd48000ff].
Bus 1, device 0, function 0:
VGA compatible controller: nVidia Corporation NV11 (GeForce2 MX) (rev 161).
IRQ 11.
Master Capable. Latency=64. Min Gnt=5.Max Lat=1.
Non-prefetchable 32 bit memory at 0xd6000000 [0xd6ffffff].
Prefetchable 32 bit memory at 0xd8000000 [0xdfffffff].
