Die Aktivierung dieser Karte ist als eth0 ist einfach nicht möglich.
Bin am verzweifeln.
Die Karte wird erkannt, jedoch wird bei jedem Versuch sie zu aktivieren die Meldung "IP-Informationen werden für eth0 bestimmt ...... fehlgeschlagen" ausgeben.
Der Kernel ist 2.4.20, das passende Modul 8139too für diese Karte wird auch geladen.
Spezifikationen wie folgt:
ethtool für eth0 führt zu:
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 10Mb/s
Duplex: Half
Port: MII
PHYAD: 32
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: p
Current message level: 0xffffffff (-1)
Link detected: yes
cat /proc/pci führt zu:
Bus 1, device 10, function 0:
Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 16).
IRQ 11.
Master Capable. Latency=32. Min Gnt=32.Max Lat=64.
I/O at 0xc800 [0xc8ff].
Non-prefetchable 32 bit memory at 0xe6000000 [0xe60000ff].
ifconfig fühhrt zu:
eth0 Protokoll:Ethernet Hardware Adresse 00:30:84:3A:1A:D1
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:17 errors:0 dropped:0 overruns:0 carrier:0
Kollisionen:0 Sendewarteschlangenlänge:100
RX bytes:0 (0.0 b) TX bytes:5814 (5.6 Kb)
Interrupt:11 Basisadresse:0x2000
Bitte, bitte helft mir !!!
